Jump to content

Plate scale

From Wikipedia, the free encyclopedia
Plate scale can be derived using this image assuming that the angle is very small (so that tan(theta) is approximately theta).

The plate scale of a telescope connects the angular separation of an object with the linear separation of its image at the focal plane.

If focal length is measured in mm, the plate scale in radians per mm is given by angular separation θ and the linear separation of the image at the focal plane s, or by simply the focal length f:

since

Plate scale is usually expressed in arcseconds per mm:

where f is in mm,[1] or expressed in arcseconds per pixel after further division through the pixel scale.

Plate scale on JWST FGS/NIRISS

[edit]

The plate scale of the James Webb Space Telescope component Fine Guidance Sensor and Near Infrared Imager and Slitless Spectrograph is about 0.065 arcsec/pixel.[2] It uses a 2048 x 2048 pixel array with a pixel size of 18 microns a side with a field of view of 2.2' x 2.2' [3]

See also

[edit]

Notes

[edit]
  1. ^ Carroll, Bradley; Ostlie, Dale. An Introduction to Modern Astrophysics (1st ed.). p. 163.
  2. ^ http://www.stsci.edu/jwst/instruments/niriss/instrumentdesign [dead link]
  3. ^ http://www.stsci.edu/jwst/instruments/niriss/instrumentdesign [dead link]